EasyManua.ls Logo

Cirrus DESIGN SR20 - Landing Without Elevator Control

Cirrus DESIGN SR20
392 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P/N 13999-002 Info Manual 3-25
Cirrus Design Section 3
SR20 Emergency Procedures
Landing Without Elevator Control
The pitch trim spring cartridge is attached directly to the elevator and
provides a backup should you lose the primary elevator control
system. Set elevator trim for a 80 KIAS approach to landing.
Thereafter, do not change the trim setting until in the landing flare.
During the flare, the nose-down moment resulting from a power
reduction may cause the airplane to hit on the nosewheel. At
touchdown, bring the power lever to idle.
1. Flaps ................................................................................SET 50%
2. Trim ............................................................................ SET 80 KIAS
3. Power ....................................AS REQUIRED FOR GLIDE ANGLE
September 2011

Table of Contents

Other manuals for Cirrus DESIGN SR20

Related product manuals