Ports
• 24 Gigabit Ethernet ports (with Auto MDI/X). Port 1 accepts PoE input.
• 2 SFP+ cages, which accept both 1.25 Gb SFP and 10 Gb SFP+ modules.
• RJ45 serial port—disabled by default.
LED Indicators
• PWR—Indicates the device is powered on.
• USR—An LED that can be customized by CIS. Default is off.
• Ethernet LEDs—Indicates network activity for each port.
• SFP+ ACT/LINK—Indicates activity on the SFP ports.
• SFP+ 10G—Indicates a 10 Gigabit link on an SFP port.
Buttons
Reset button: Hold this button while the device is powered off, then apply power. Keep holding until the
USR LED light starts flashing, (5 seconds) then release the button to reset to the default CIS configuration.
You can use this procedure if you have forgotten the password to access the device, or simply wish to
return the unit to its default configuration state.
Input Power Requirements
The CIS-CRS326-24G is powered via the included 24V adapter or via PoE input on port 1 (10-30V DC).
To Next Page
Loading...