2-9
Cisco Video Surveillance 6030 IP Camera Installation Guide
OL-28492-02
Chapter 2 Camera Installation
Installing the IP Camera with a Vandal Resistant Enclosure
Step 14 Use the included wrench and tighten the four dome cover screws to secure the dome cover to the camera.
Make sure all parts of the camera are securely installed.
What to do next
Complete the following procedures:
• After you install the IP camera, follow the instructions in the “Performing the Initial Setup of the IP
Camera” section on page 3-1 to access the IP camera through your network.
• After completing the initial setup, use the IP camera user interface to adjust the focal length and
zoom factor. For more information, see the
“Adjusting the IP Camera Focus and Zoom” section on
page 4-3.
To Next Page
Loading...
