CHAPTER
4-1
Cisco 6160 Hardware Installation Guide
OL-2190-02 B0
4
Installing a Cisco 6160 Without a POTS Splitter
Configuration
This chapter provides installation procedures for installing a Cisco 6160 without a POTS splitter for
xDSL data traffic.
Note The installation procedures in this chapter apply to a Cisco 6160 system shipped with the individual
hardware components preinstalled. For information about installing or replacing field-replaceable units
(FRUs) in the Cisco 6160 chassis, see Chapter 6, “Upgrading and Maintaining the Cisco 6160 System.”
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Caution Before you begin the installation procedures, read the entire chapter for important information and
safety warnings.
Note Before installing and cabling the equipment, be aware of standard safety practices and the hazards
involved in working with electrical circuitry to prevent accidents. See the “Safety Requirements” section
on page 2-1 for all cautions and warnings that you need to ensure a safe and hazard-free installation.
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information for the Cisco 6160 System document that accompanied this product.
Note See the “Cisco 6160 Without a POTS Splitter Configuration” section on page 1-4 for more information
about configuration components.
To Next Page
Need help?
General