2-50 Cisco 7010 Hardware Installation and Maintenance
Initial Configuration Information
Figure 2-40 7010 Interface Processor Slot Locations and Numbering
Table 2-17 Port Configuration Worksheet
FEIPs Enter slot locations and port addresses on Configuration Worksheet
TRIPs Enter slot locations and port addresses on Configuration Worksheet
FIPs Enter slot locations and port addresses on Configuration Worksheet
FSIPs Enter slot locations and port addresses on Configuration Worksheet
HIPs Enter slot locations and port addresses on Configuration Worksheet
MIPs Enter slot locations and port addresses on Configuration Worksheet
Other optional equipment:
Slot 0—Refer to Figure 2-40 Slot 1—Refer to Figure 2-40 Slot 2—Refer to Figure 2-40
Port 0
Port 1
Port 2
Port 3
Port 4
Component Description Rec’d
H2359
RP slot
SP or SSP slot
Interface processor slot 1
DC OK LED
Power switch
Chassis ground
screw
Power receptacle
Interface processor slot 2
Interface processor slot 0
AC-input power supply
To Next Page
Loading...
