3-2 Cisco 7010 Hardware Installation and Maintenance
Rack-Mounting the Chassis
Figure 3-1 Typical 19-Inch Equipment Rack Posts and Mounting Strips
Tools and Equipment
Have the following tools on hand before you begin the rack installation:
• Number 1 and number 2 Phillips screwdrivers
• 1/4-inch and 3/16-inch flat-blade screwdrivers
• Tape measure
• Level (optional)
The rack-mount kit includes the following parts:
• Two chassis ears
• Four M3 x 8-mm Phillips flathead screws to secure the ears to the chassis
• Eight 10-32 x 3/8-inch slotted binderhead screws to secure the chassis ears to the rack rails
When installing the router in an enclosed rack, removing the door temporarily may provide
additional clearance. We recommend that you have someone to assist you by supporting the chassis
while you mount it in the rack by securing the chassis ears to the rack-mounting strips.
18.312"
hole C to C
17.72" min.
Rack posts
Mounting strips
110 VAC
outlets
H2048
To Next Page
Loading...
