Installing the Router 3-5
Rack-Mounting the Chassis
Unless you have a way of supporting the chassis in the rack while you install the fasteners, get
another person to assist you so that one person can support the chassis while the other installs the
fasteners.
Warning Ensure that heavier equipment is installed near the bottom of the rack to maintain a low
center of gravity. Otherwise, because the two front posts bear the entire weight of the chassis, the
rack could become top-heavy and tip over if it is not stabilized with heavier equipment at the bottom
or anchored to the floor.
Figure 3-4 Installing the Chassis in a Telco Rack
Warning
When installing the router in Telco-type racks, ensure that the rack is bolted to the floor
and, if necessary, anchored with appropriate fixtures.
To install the chassis in the rack, follow these steps:
Step 1 On the chassis, ensure that all captive screws (on the processor modules and on the access
cover) are tightened and the components are secure.
Step 2 Make sure that your path to the rack is unobstructed. If the rack is on wheels, ensure that
the brakes are engaged or that the rack is otherwise stabilized.
Warning Never attempt to lift or tilt the chassis with the handles on the interface processor carriers
or with the cable management brackets. Neither the handles nor the brackets are designed to support
the weight of the chassis.
H2052
Telco rack
Chassis front
To Next Page
Loading...
