Installing the Router 3-9
Connecting Power
Step 4 Feed the 10-AWG, RTN and –48V wires through the large hole in the face of the terminal
block cover. (See Figure 3-6b.) Feed a sufficient length (approximately 3 inches) of these
two wires away from you, through the terminal block cover.
Step 5 Attach and tighten the RTN and –48V leads to the terminal block. (See Figure 3-6d.) Verify
that you are connecting the appropriate leads to the correct terminal block posts. The color
coding is up to you, but should match the connections at the DC power source.
Warning Incorrectly wiring the terminal block could create a shock hazard and could damage the
power supply, power source, and the Cisco 7010 chassis components. Make certain there are no
loose strands that could cause a short circuit of the power supply and power source.
Step 6 Using a nylon cable tie that you provide, fasten the RTN and –48V leads to the terminal
block cover, as shown in Figure 3-6c. Insert the nylon cable tie through the small hole at
the bottom of the terminal block cover and around the two leads.
Step 7 Bundle the RTN and –48V wires behind the terminal block cover so that the cover fits over
the wires and the terminal block. (See Figure 3-6b.) Take care not to strain the leads on the
terminal block or crimp the wires behind the cover. (See Figure 3-6a.)
Figure 3-6 Removing and Replacing the Terminal Block Cover and Power Cable Leads
Caution: Do not strain the connection at the terminal block
H2537
a
c
d
Terminal block
cover and
captive screws
-48/-60V
20/16A
—
RTN
-48
-48/-60V
20/16A
—
RTN
-48
-48/-60V
20/16A
—
RTN
-48
Ground
terminal
POWER SUPPLY
TERM. BLOCK COVER
- USE ONLY WITH
NEC CLASS 3
WIRING
- USE COPPER
CONDUCTORS
POWER SUPPLY
TERM. BLOCK COVER
- USE ONLY WITH
NEC CLASS 3
WIRING
- USE COPPER
CONDUCTORS
Cable strain relief
nylon cable tie
b
To Next Page
Loading...
