Installing the Router 3-13
Connecting Interface Cables
Step 3 To ensure that the clip is not pulled off when adjacent interface processors are removed,
position the clip parallel to the orientation of the AIP. (See Figure 3-8d.)
Figure 3-8 Installing the CAB-ATM-DS3/E3 Cable and EMI Filter Clip
Assembly—Horizontal Orientation Shown
Note For additional information, refer to the Asynchronous Transfer Mode Interface Processor
(AIP) Installation and Configuration configuration note (Document Number 78-1214-xx, where xx
is the latest version), which is available on UniverCD or in print.
ATM INTERFACE PROCESSOR
UNI-34CX
XTMR
RCVR
White insulator
ATM INTERFACE PROCESSOR
UNI-34CX
XTMR
RCVR
H2897
To TX of switch
To RX of switch
ATM INTERFACE PROCESSOR
UNI-34CX
XTMR
RCVR
EMI filter
clip
a
b
d
c
White insulator
To Next Page
Loading...
