Installing the Router 3-29
Using the Flash Memory Card
Figure 3-27 Installing the Metal Sleeve
Step 2
Hold the Flash memory card with the connector end of the card toward the PCMCIA slot.
The product label should face to the right, as shown in Figure 3-28a.
Note The Flash memory card is keyed and cannot be seated the wrong way.
Step 3 Insert the card into the slot until the card completely seats in the connector at the back of
the slot. Note that the card does not insert all the way inside the RP; a portion of the card
and sleeve remain outside of the slot. Do not attempt to force the card past this point.
Step 4 To remove the card, grasp the card near the slot and squeeze the sleeve together to release
it from the slot. Then pull the card free from the connector at the back of the slot. (See
Figure 3-28c.)
Step 5 Place the removed Flash memory card on an antistatic surface or in a static shielding bag.
Series 2+
8 MByte Memory Card
PERFORMANCE PLUS
CAUTION!
H4225
Connector end
To Next Page
Loading...
