Cisco 7000 Series - Page 17

Product Overview 1-3
Physical Description
Figure 1-1 Cisco 7000 Series Routers
The front, or noninterface processor end, of the Cisco 7010 is a removable cover panel that is secured
with two captive slotted fasteners. (See Figure 1-2.) Removing the cover panel provides access to
the three internal components: the arbiter, power supply, and fan tray.
Figure 1-2 Cisco 7010 Chassis Cover Panel
The interface processor end of the router contains the five-processor slots, the AC-input receptacle,
the power switch, and a power status LED indicator. The processor slots contain the RP, SP (or SSP),
and up to three interface processors. When viewing the router from the interface processor end, the
RP is in the top slot (the RP slot), and the SP (or SSP) is in the slot directly below the RP. The
remaining three slots are numbered from the bottom up beginning with slot 0 (the bottom slot)
through 2 (the center slot).
H1999
I
O
DC FAIL
AC POWER
I
O
DC FAIL
AC POWER
Cisco 7000
Cisco 7010
H2952
Captive fasteners