Cisco 7000 Series - Replacing System Software Eproms

To Next Page

To Previous Page

5-30 Cisco 7010 Hardware Installation and Maintenance

Installing and Configuring Processor Modules

An example of the copy startup-config slot0:filename command follows:

Router# copy startup-config:myfile1 slot0:myfile1

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

Note In the preceding example, the exclamation points (!!!) appear as the file is copied. The “C”

characters signify calculation of the checksum, which is a verification that the file has been correctly

copied.

Copying a Configuration File from a Flash Memory Card to NVRAM

Following is the procedure for copying your configuration file from the Flash memory card in the

PCMCIA slot, back to NVRAM. Use the command copy [ slot0 | slot1 ]:filename startup-config

for this copy procedure, where [slot0 | slot1 ]:filename is the source of the file (Flash memory card)

and startup-config is the destination (NVRAM).

An example of the copy slot0:filename startup-config command follows:

Router# copy slot0:myfile1 startup-config

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

Note In the preceding example, the exclamation points (!!!) appear as the file is copied. The “C”

characters signify calculation of the checksum, which is a verification that the file has been correctly

copied.

Replacing System Software EPROMs

This section describes the procedure for upgrading the system software by replacing the eight

erasable programmable read-only memory (EPROM) components on the RP and, if necessary,

changing the positions of the jumpers on J3 and J4. (The components actually are EPROMs;

however they are commonly known as the software or boot ROMs.) Although most system software

Related product manuals