Maintenance 5-55
Installing and Configuring Processor Modules
Step 8 Insert the two long Phillips-head screws through the two standoffs and finger-tighten them.
These screws extend through the standoffs and the FSIP board and thread into the metal
carrier.
Step 9 Install a lockwasher on each of the four jackscrews.
Step 10 On the front of the carrier faceplate, insert the four jackscrews through the front of the
faceplate and into the holes on either side of both port connectors.
Step 11 When all screws and connectors are aligned properly, use a Phillips screwdriver to tighten
the standoff screws and a 3/16-inch nut driver to tighten the four jackscrews. Do not
overtighten any of the screws.
Step 12 Proceed to the next section to reinstall the FSIP in the chassis.
To Next Page
Loading...
