5-56 Cisco 7010 Hardware Installation and Maintenance
Installing and Configuring Processor Modules
Figure 5-19 Installing FSIP Port Adapters
Replacing the FSIP in the Chassis
There should now be four or eight port adapters installed on the FSIP. If there are not, do not install
the FSIP until you install all port adapters or until you install a blank interface processor filler in the
FSIP slot.
Caution Handle interface processors by the handles and carrier edges only to prevent ESD damage.
H1599a
Board stiffener
and EMI shield
To Next Page
Loading...
