Cisco 7000 Series - CIP Leds

B-4 Cisco 7010 Hardware Installation and Maintenance
Interface Processor LEDs
• Online—For the ECA, this LED indicates that an establish-logical-path request has been
received from the channel.
For the PCA, this LED indicates that the PCA is ready to establish connection to the host channel.
Figure B-5 CIP LEDs
Following are the sequences for the CIP LED indicators. The enabled LED is not part of the
following sequences. On cold boots, the following four LED sequences apply:
The following sequence indicates that the CIP is waiting for commands from the RP.
On warm boots, the LEDs flash briefly. On downloads, the following three LED sequences apply;
the first indicates that the system is downloading volatile programmable logic device (VPLD) code:
The following sequence indicates that the CIP is downloading microcode:
Present Loaded Signal Online
Port 1 On On Off Off
Port 0 Off Off Off Off
Present Loaded Signal Online
Port 1 On On On On
Port 0 On On Off Off
Present Loaded Signal Online
Port 1 On On On On
Port 0 On On On On
Present Loaded Signal Online
Port 1 Off Off Off Off
Port 0 Off Off Off Off
Present Loaded Signal Online
Port 1 On On On On
Port 0 On On On Off
Present Loaded Signal Online
Port 1 Off Off Off Off
Port 0 On On On On
PRESENT
LOADED
SIGNAL
ONLINE
PORT 0
PORT 1
H2433
ENABLED