Cisco 7000 Series - Page 283

Index 9
Token Ring 2-28, A-5
V.35 1-30, A-10
X.21 1-30
port adapters
cable pinouts A-6
cable unattached message 5-50
connectors 2-38
description 1-30
replacing 5-51
power
backplane harness 5-72
cord 1-7, 2-2, 4-6, 5-71, 5-72
DC status 1-41
disabled 1-41
distribution 5-72
emergency switch 2-2
internal DC voltage 1-8, 4-4
LED 1-8, 4-4
service 3-11
site 2-4
specifications 1-5
status 1-8, 4-4
subsystem for troubleshooting 4-3
surge suppression 2-5
ungrounded 2-3
power factor corrector 1-5, 2-4
power harness cover 5-72
power supply
and environmental monitor 1-41
cable retention clip 5-72
description 1-7
handles 2-3, 5-79
LED 1-7, 3-27, 4-4
PWR-7010AC FRU 5-71
shutdown 1-41
status 1-8, 4-4
troubleshooting 4-3
powerfails 1-45
PRE-FSIP 1-22
procedures
copying to Flash 5-22
maintenance ??–5-23
recovering from a lost password 5-23
processor
modules, definition 1-4
shutdown 1-41
system 1-11
protocols 1-1
PWR-7010AC power supply FRU 5-71
R
rack mount kit
ACS-7010RMK= FRU 5-71
installing 3-1
radio frequency interference
See RFI
read-only memory
See ROM 1-11
Receive LED on EIP
See LEDs
recovering a lost password 5-23
refresh, environmental display 1-45
reliability, system 1-1
reload command 5-19
replaceable system components 5-1
See FURs
reports, environmental 1-42
reset switch B-2
RFI
ring
dual 2-34
in FDDI networks 2-32
in Token Ring networks 2-29
recovery 2-35
speed 2-28
ring-speed command 2-32
RJ-45
cable attachment 3-14
cable specifications 2-6
connections, FEIP 2-27
LED B-6
pinouts, FEIP A-4
ROM
booting from 5-14
loading microcode from 5-12
microcode 1-22, 5-10
ROM monitor, system boot 5-15
route processor
See RP
RP
and bus access 1-6
boot sequence 4-5
configuration 5-2
configuring 5-13
description 1-11
Flash write-protection 5-17
installation 5-2
LEDs 4-5, B-2
normal startup 4-5
operating voltages 1-8, 4-4
replacing 5-13
subsystem for troubleshooting 4-8
RS-232
cable pinouts A-7
description 2-41
port A-7
port adapter 1-30
serial port adapter cable 2-38