1-14
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
Chapter 1 Cisco 7500 Series Product Overview
Cisco 7507-MX Overview
Cisco 7507-MX System Specifications
Table 1-3 lists the specifications for the Cisco 7507-MX system.
Table 1-3 Cisco 7507-MX Specifications
Description Specification
High-speed backplane Two 1.0677-Gbps CyBuses, 5 interface processor slots, 2 RSP slots
Dimensions (H x W x D) 19.25 x 17.5 x 25.1 in. (48.90 x 44.45 x 63.75 cm)
Chassis depth including power cord is 28 in. (71.12 cm)
Weight Chassis only: 76 lb (34.47 kg)
Chassis fully configured, using all slots and 2 power supplies:
145 lb (65.76 kg)
Power supply 700W maximum (for AC-input and DC-input power supplies)
Power dissipation 626W maximum configuration
530W typical with maximum configuration
Heat dissipation 1200W (4100 Btu/hr) with AC-input
300W (1024 Btu/hr) with DC-input
AC-input voltage 100 to 240 VAC, wide input with power factor corrector (PFC)
AC-input cable 12 AWG, with 3 leads, an IEC-320 plug on the router end, and a country-dependent plug
on the power source end
Frequency 50 to 60 Hz autoranging
AC-input ratings 10A maximum @ 100 VAC, 6A maximum @ 240 VAC, chassis fully configured
DC-input ratings –40 VDC minimum, –48 VDC nominal, –72 VDC maximum
Power distribution +5.2 VDC @ 95A, +12 VDC @ 15A, –12 VDC @ 5A, +24 VDC @ 4A
DC-input cable 8 AWG, recommended minimum wire gauge (you provide the wire)
Airflow 140 cfm through the system blower
Operating temperature 32 to 104°F (0 to 40°C)
Nonoperating temperature –4 to 149°F (–20 to 65°C)
Humidity 10 to 90%, noncondensing
Software requirement RSP2 – Cisco IOS Release 10.3(6) or a later release of 10.3
RSP4/4+ – Cisco IOS Release 11.1(8)CA or a later release of 11.1
RSP8 – Cisco IOS Release 12.0(9)S or a later release of 12.0 S
RSP16 – Cisco IOS Release 12.1(12)E and later and Cisco IOS 12.0(21.02)S and later
Agency approvals Safety: UL 1950, CSA 22.2-950, EN60950: 1992 EMI: FCC Class A, EN55022 Class B,
VCCI Class 2
To Next Page
Loading...
