1-12
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 1 An Overview of the Conference Station
Overview of Configuring and Installing Conference Stations
Installing Conference Stations
After you have added the conference stations to the Cisco Unified Communications Manager database,
you can complete the conference station installation. You (or the conference station users) can install the
conference station at the users’s location. The Cisco
Unified IP Conference Station 7937G Installation
Guide provides directions for connecting the conference station to the network, and connecting any
optional accessories to the conference station. You can access the guide at the following URL:
http://www.cisco.com/en/US/products/hw/phones/ps379/tsd_products_support_series_home.html
After the conference station is connected to the network, the conference station startup process begins
and the conference station registers with Cisco
Unified Communications Manager. To finish installing
the conference station, configure the network settings on the conference station depending on whether
you enable or disable DHCP service.
If you used auto-registration, you need to update the specific configuration information for the
conference station such as associating the conference station with a user, changing the button table, or
directory number.
Checklist for Installing the Conference Station
Table 1-5 provides an overview and checklist of installation tasks for the conference station. The list
presents a suggested order to guide you through the conference station installation. Some tasks are
optional, depending on your system and user needs. For detailed procedures and information, refer to
the sources in the list.
Ta b l e 1-5 Checklist for Installing the Cisco Unified IP Conference Station 7937G
Task Purpose For More Information
1. Choose the power source for the
conference station:
• Power over Ethernet (PoE)
• External power supply
Determines how the
conference station receives
power.
See Providing Power to
the Conference Station,
page 2-2.
2. Assemble the conference station,
adjust conference station placement,
and connect the network cable.
Locates and installs the
conference station in the
network.
See Installing the
Conference Station,
page 3-4.
3. Monitor the conference station
startup process.
Verifies that the conference
station is configured properly.
See Verifying the
Conference Station
Startup Process, page 3-8.
To Next Page
Loading...
