Cisco 7937G - Unified IP Conference Station VoIP Phone - Device Configuration Menu

4-8
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 4 Configuring Settings on the Conference Station
Device Configuration Menu
Related Topics
• Displaying a Configuration Menu, page 4-2
• Unlocking and Locking Options, page 4-3
• Editing Values, page 4-3
• Overview of Options Configurable from a Conference Station, page 4-4
• Device Configuration Menu, page 4-8
Device Configuration Menu
The Device Configuration menu provides access to five sub-menus from which you can view a variety
of settings that are specified in the configuration file for a conference station. (The conference station
downloads the configuration file from the TFTP server.) These sub-menus are:
• CallManager Configuration Menu, page 4-9
• HTTP Configuration Menu, page 4-10
• Locale Configuration Menu, page 4-11
• Security Configuration Menu, page 4-11
• QoS Configuration Menu, page 4-12
Alternate TFTP Indicates whether the conference
station is using an alternative TFTP
server.
1. Unlock network configuration options. For more information,
see the
“Unlocking and Locking Options” section on page 4-3.
2. Choose Applications > Settings > Network Configuration >
Alternate TFTP.
3. Choose Enabled if the conference station should use an
alternate TFTP server, or Disabled if the conference station
should not use an alternate TFTP server.
4. Press Select, and then press Save.
Ethernet
Configuration
Speed and duplex of the Ethernet
port (labeled LAN on the
conference station). Valid values:
• Auto Negotiate
• 10 Half—10-BaseT/half
duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half
duplex
• 100 Full—100-BaseT/full
duplex
1. Unlock network configuration options. For more information,
see the
“Unlocking and Locking Options” section on page 4-3.
2. Choose Applications > Settings > Network Configuration >
Ethernet Configuration.
3. Select a new Ethernet Configuration setting.
4. Press Select, and then press Save.
MAC Address Unique Media Access Control
(MAC) address of the conference
station.
Display only—Cannot configure.
Table 4-3 Network Configuration Menu Options (continued)
Option Description To Change