Cisco 7937G - Unified IP Conference Station VoIP Phone - Callmanager Configuration Menu

4-9
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Chapter 4 Configuring Settings on the Conference Station
Device Configuration Menu
Note You update the settings in the Device Configuration menu from Cisco Unified Communications
Manager, not from the conference station.
For instructions about how to access the Device Configuration menu and its sub-menus, see the
“Displaying a Configuration Menu” section on page 4-2.
CallManager Configuration Menu
The CallManager Configuration menu contains the options CallManager 1, CallManager 2,
CallManager
3, CallManager 4, and CallManager 5. These options show the servers that are available
for processing calls from the conference station, in prioritized order.
To change these options, use Cisco Unified Communications Manager Administration.
For an available server, an option on the CallManager Configuration menu will show the server
IP
address or name and one of the states shown in Table 4-4.
An option may also display one or more of the designations shown in Table 4-5.
Ta b l e 4-4 Cisco Unified Communications Manager Server States
State Description
Active Cisco Unified Communications Manager server from which the
conference
station is currently receiving call-processing services
Standby Cisco Unified Communications Manager server to which the
conference
station switches if the current server becomes unavailable
Blank No current connection to this Cisco Unified Communications Manager
server
Ta b l e 4-5 Cisco Unified Communications Manager Server Designations
Designation Description
SRST Indicates a Survivable Remote Site Telephony router capable of providing
Cisco Unified
Communications Manager functionality with a limited
feature set. This router assumes control of call processing if all other
Cisco
Unified Communications Manager servers become unreachable. The
SRST Cisco Unified
Communications Manager always appears last in the
list of servers, even if it is active.
You configure an SRST router address in the
Cisco
Unified Communications Manager Administration SRST Reference
Configuration page (choose System > SRST). You configure an SRST
reference in the Device Pool Configuration page (choose System >
Device
Pool).
TFTP Indicates that the conference station was unable to register with a
Cisco
Unified Communications Manager listed in its configuration file and
that it registered with the TFTP server instead.