Cisco 7941G - Set Up Abbreviated Dialing Codes; Phone Service Setup on Web

To ChangeDescriptionOption
Set TFTP Server 2 Field, on page 80Optional backup TFTP server that the
phone with an IPv4 address uses if the
primary TFTP server is unavailable.
If neither the primary TFTP server nor
the backup TFTP server is listed in the
CTL or ITL files on the phone, you must
unlock the file before you can save
changes to the TFTP Server 2 option. In
this case, the phone will delete the file
when you save changes to the TFTP
Server 2 option. A new CTL file or ITL
file is downloaded from the new TFTP
Server 2 address.
When the phone looks for its TFTP
server, it gives precedence to manually
assigned TFTP servers, regardless of the
protocol. If your configuration includes
both IPv6 and IPv4 TFTP servers, the
phone prioritizes the order that it looks
for its TFTP server by giving priority to
manually assigned IPv6 TFTP servers and
IPv4 TFTP servers. The phone looks for
its TFTP server in the following order:
1
Manually assigned IPv6 TFTP servers
2
Manually assigned IPv4 TFTP servers
3
DHCPv6 assigned TFTP servers
4
DHCP assigned TFTP servers
For information about the CTL
and ITL files, see Cisco Unified
Communications Manager
Security Guide. For information
about unlocking CTL and ITL
files, see Unlock CTL and ITL
Files, on page 110.
Note
TFTP Server 2
Display only—Cannot configure.
Indicates whether the phone obtains its
configuration from a Bootstrap Protocol
(BootP) server instead of from a DHCP
server.
BOOTP Server
The following table describes the IPv6 configuration menu options.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
70
Cisco Unified IP Phone Settings
Network Configuration Menu