Cisco 7975G - Page 88

To ChangeDescriptionOption
Set Admin VLAN ID Field, on page
77
Auxiliary VLAN in which the phone is a
member.
Used only if the phone does not receive an
auxiliary VLAN from the switch; otherwise it
is ignored.
Admin. VLAN ID
Set SW Port Configuration Field, on
page 77
Speed and duplex of the network port. Valid
values:
•
Auto Negotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure
the port on the switch to the same
speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you
must change the PC Port Configuration option
to the same setting.
SW Port
Configuration
Set PC Port Configuration Field, on
page 77
Speed and duplex of the access port. Valid
values:
•
Autonegotiate
• 10 Half—10-BaseT/half duplex
• 10 Full—10-BaseT/full duplex
• 100 Half—100-BaseT/half duplex
• 100 Full—100-BaseT/full duplex
• 1000 Full—1000-BaseT/full duplex
If the phone is connected to a switch, configure
the port on the switch to the same
speed/duplex as the phone, or configure both
to auto-negotiate.
If you change the setting of this option, you
must change the SW Port Configuration option
to the same setting.
PC Port
Configuration
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
68
Cisco Unified IP Phone Settings
Network Configuration Menu