Cisco 800M series - Mounting on a Rack

2-6
Cisco 800M Series Integrated Services Router Hardware Installation Guide
Chapter 2 Installing the Router
Figure 2-4 Installing the Router to the Wall
Note For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
washers must be size number 10.
Step 4 Route the cables so that they do not put a strain on the connectors or mounting hardware. To comply with
IP 41, cables should be routed down relative to the router to prevent water from traveling on the cables.
Mounting on a Rack
The two brackets provided along with the router which can be used for wall mount or rack mount. These
brackets support mounted the router on a standard 19 inch rack. The brackets must be rotated 90 degrees
and used for mounting it on the rack.
364600