3-2
Cisco 800M Series Integrated Services Router Hardware Installation Guide
Chapter 3 Connecting the Router
Connecting a PC, Server, or Workstation
To connect a PC (or other Ethernet devices) to an Ethernet switch port, follow these steps:
Step 1 Connect one end of the Ethernet cable to an Ethernet switch port on the router, as shown in Figure 3-1.
Note The connections remain the same for a 4 port module.
Figure 3-1 Connecting a Server, PC, or Workstation
Step 2 Connect the other end of the cable to the RJ-45 port on the network interface card (NIC) that is installed
in the PC, server, or workstation.
Step 3 (Optional) Connect additional servers, PCs, or workstations to the other Ethernet switch ports.
364927
3
2
1
1 Ethernet cable 3 RJ-45 port on the network interface card
2 Ethernet switch port on the router
To Next Page
Loading...
