Cisco 8832 Administration Guide

DescriptionItem
Number of seconds that have concealment events (lost
frames) from the start of the voice stream (includes
severely concealed seconds).
Conceal Seconds
Number of seconds that have more than 5 percent
concealment events (lost frames) from the start of the
voice stream.
Severely Conceal Seconds
Estimate of the network latency, expressed in
milliseconds. Represents a running average of the
round-trip delay, measured when RTCP receiver
report blocks are received.
Latency
Cisco IP Phone Web Page
Each Cisco IP Phone has a web page from which you can view a variety of information about the phone,
including:
• Device Information: Displays device settings and related information for the phone.
• Network Setup: Displays network setup information and information about other phone settings.
• Network Statistics: Displays hyperlinks that provide information about network traffic.
• Device Logs: Displays hyperlinks that provide information that you can use for troubleshooting.
• Streaming Statistic: Displays hyperlinks to a variety of streaming statistics.
This section describes the information that you can obtain from the phone web page. You can use this
information to remotely monitor the operation of a phone and to assist with troubleshooting.
You can also obtain much of this information directly from a phone.
Access the Phone Web Page
If you cannot access the web page, it may be disabled by default.
Note
Procedure
Step 1 Obtain the IP address of the Cisco IP Phone by using one of these methods:
a) Search for the phone in Cisco Unified Communications Manager Administration by choosing Device >
Phone. Phones that register with Cisco Unified Communications Manager display the IP address on the
Find and List Phones window and at the top of the Phone Configuration window.
b) On the phone, press Settings > System Information and then scroll to the IPv4 address field..
Step 2 Open a web browser and enter the following URL, where IP_address is the IP address of the Cisco IP Phone:
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
136
Cisco IP Conference Phone Troubleshooting
Cisco IP Phone Web Page

Cisco 8832 Specifications

General

Control type	Buttons
Display type	LCD
Product type	IP conference phone
Voice codecs	G.711a, G.711u, G.722, G.729A, G.729ab, OPUS, iLBC
Certification	CE Markings per directives 2014/30/EU and 2014/53/EU and 2014/35/EU \u2028 \u2028 UL 60950 Second Edition \u2028 CAN/CSA-C22.2 No. 60950 Second Edition \u2028 EN 60950 Second Edition (including A11 and A12) IEC 60950 Second Edition (including A11 and A12) EN 60950-1 IEC 60950-1 AS/NZS 60950.1 47CFR Part 15 (CFR 47) Class B AS/NZS CISPR32 Class B \u2028 CISPR32 \u2028Class B EN55032 \u2028 Class B EN 300 386 ICES003 Class B \u2028 VCCI Class B \u2028 EN61000-3-2 \u2028 EN61000-3-3 \u2028 EN61000-4-2 IEC61000-4-2 EN61000-4-3 IEC61000-4-3 EN61000-4-6 IEC61000-4-6 KN22 Class B \u2028 EN55024 \u2028 CISPR24 \u2028 KN24 Armadillo Light AS/ACIF S004 NZPTC220
Product color	Charcoal
Frequency range	100 - 20000 Hz
Built-in display	Yes
Display diagonal	3.9 \
Languages support	ARA, BUL, CAT, CHI (SIMPL), CHI (TR), CZE, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HEB, HUN, ITA, JPN, KOR, LAT, LIT, NOR, POL, POR, RUM, RUS, SER, SLK, SLV, SWE, TUR, UKR
Display resolution	480 x 128 pixels
Security algorithms	EAP-FAST, EAP-TLS, SHA-256, SSH
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	IPv4, IPv6, SIP, SDP, UDP, DHCP, GARP, TFTP, HTTPS, RTP, RTCP, Cisco Discovery Protocol, LLDP
Cables included	USB
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %
USB connector type	USB Type-C
RJ-45 ports quantity	1

Weight and Dimensions

Width	278 mm
Height	61 mm
Weight	1850 g