Step 1 Determine the required distance between mounting holes on the router. For Cisco 900 routers, the distance between
mounting holes is 4.15 inches. Figure below shows the wall-mount holes located on the underside of the router.
Figure 15: Router with Wall-mount Holes on the Underside
Step 2 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a hole in the wall.
Step 3 Insert the screws, with anchors, into the wall. Leave 1/8 inch (0.32 cm) between the screw head and the wall.
Hardware Installation Guide for the Cisco 900 Series Integrated Services Router
22
Install and Connect the Router
Wall Mount
To Next Page
Loading...
