Cisco 9971 - WLAN Signal Indicator

104 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide

100

WLAN Signal Indicator

As of the 9.0(2) release, the WLAN status indicator will be visible in all menus within Administrator Settings.

In the initial release, the WLAN signal indicator was only visible in the WLAN Setup menu.

Table of Contents

Cisco Unified Ip Phone 99711
Revision History2
Table of Contents3
Cisco Unified IP Phone 9971 Overview6
Requirements6
- Site Survey6
- RF Validation6
- Call Control8
- Protocols8
- Access Points9
- Antennas11
Models11
- World Mode (802.11D)12
- Radio Characteristics13
- Language Support14
Bluetooth14
- Bluetooth Profiles15
- Coexistence (802.11B/G + Bluetooth)15
Video Calls16
Security17
- Extensible Authentication Protocol - Flexible Authentication Via Secure Tunneling (EAP-FAST)17
- Fast Secure Roaming (FSR)19
- EAP and User Database Compatibility19
Power Management20
- Delivery Traffic Indicator Message (DTIM)20
Quality of Service (Qos)20
- Configuring Qos in Cisco Unified Communications Manager21
- Configuring Qos Policies for the Network21
- Call Admission Control23
  - Pre-Call Admission Control24
  - Roaming Admission Control24
- Traffic Classification (TCLAS)24
Roaming25
- Interband Roaming26
Designing the Wireless LAN26
- Planning Channel Usage26
- Configuring Data Rates32
- Call Capacity33
  - Video Calls33
- Dynamic Transmit Power Control (DTPC)34
- Rugged Environments34
  - Multipath35
- Verification with Site Survey Tools36
  - Cisco 9971 Site Survey37
Multicast26
Configuring Cisco Unified Communications Manager39
- Phone Button Templates39
- Security Profiles40
- G.722 and Isac Advertisement41
- Common Settings42
- Audio and Video Bit Rates42
- Configuring Video and Camera Capabilities43
- Product Specific Configuration Options44
Configuring the Cisco Unified Wireless LAN Controller and Access Points56
- SSID / WLAN Settings57
- Controller Settings62
- 802.11 Network Settings64
- AP Groups74
  - RF Profiles75
- Flexconnect Groups77
- Multicast Direct77
- Qos Profiles78
- Qos Basic Service Set (QBSS)82
- CCKM Timestamp Tolerance83
- Auto-Immune84
- WLAN Controller Advanced EAP Settings85
- Proxy ARP86
- TKIP Countermeasure Holdoff Time86
- Vlans and Cisco Autonomous Access Points87
Configuring the Cisco Unified IP Phone 997187
- Wireless LAN Settings87
- Bluetooth Settings89
- Camera Settings for Video Calls91
- Upgrading Firmware92
Troubleshooting93
- Device Information93
- Network Setup94
- Current Access Point95
- WLAN Statistics97
- Streaming Statistics97
- Device Logs98
- Traffic Stream Metrics (TSM)99
- WLAN Signal Indicator100
- WLAN Disconnect Display101
- Restoring Factory Defaults101
- Capturing a Screenshot of the Phone Display101
Healthcare Environments101
Accessories101
Additional Documentation103