Cisco AIR-AP1252AG-A-K9 - Page 5

Contents
v
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
CHAPTER 3 Troubleshooting 1250 Series Autonomous Access Points 3-1
Checking the Autonomous Access Point LEDs 3-2
Checking the Power Injector LEDs 3-4
Checking Basic Settings 3-5
Default IP Address Behavior 3-5
Enabling the Radio Interfaces 3-5
SSID 3-6
WEP Keys 3-6
Security Settings 3-6
Low Power Condition on Autonomous Access Points 3-7
Intelligent Power Management 3-7
Inline Power Status Messages 3-8
Configuring Power Using the CLI 3-11
Issuing the Cisco IOS Command Using the CLI 3-13
Configuring the Access Point System Power Settings Using a Browser 3-13
Running the Carrier Busy Test 3-16
Running the Ping Test 3-17
Resetting to the Default Configuration 3-18
Using the MODE Button 3-18
Using the Web Browser Interface 3-19
Reloading the Access Point Image 3-19
Using the MODE Button 3-19
Web Browser Interface 3-20
Browser HTTP Interface 3-20
Browser TFTP Interface 3-21
Obtaining the Access Point Image File 3-22
Connecting to the Access Point Locally 3-22
Obtaining the TFTP Server Software 3-24
CHAPTER 4 Troubleshooting 1250 Series Lightweight
Access Points
4-1
Guidelines for Using Cisco Aironet Lightweight Access Points 4-2
Using DHCP Option 43 4-2
Checking the Lightweight Access Point LEDs 4-3
Checking the Power Injector LEDs 4-6
Low Power Condition for Lightweight Access Points 4-7
Intelligent Power Management 4-7
Inline Power Status Messages 4-8