3-13
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
Low Power Condition on Autonomous Access Points
Issuing the Cisco IOS Command Using the CLI
Follow these steps to issue the Cisco IOS command for your power scenario:
Step 1 Connect a PC to the access point console port and use a terminal emulator to establish a session with the
access point (refer to the “Connecting to the Access Point Locally” section on page 3-22).
Step 2 From the global configuration mode (refer to the Cisco IOS Software Configuration Guide for Cisco
Aironet Access Points), enter the command below that applies to your power configuration (see Table 3-3
and Table 3-4):
• power inline negotiation injector installed (not required)
• no power inline negotiation injector (not required)
• power inline negotiation prestandard source
• no power inline negotiation prestandard source
Step 3 Enter the write memory command to save the setting to the access point memory.
Step 4 Enter the quit command to exit the terminal session.
Configuring the Access Point System Power Settings Using a Browser
You can also use your browser to set the access point system power settings.
Note When using the access point browser interface, you should disable your browser pop-up blocker.
Figure 3-3 shows the system power setting options and indicates the access point power status (1250
series power injector detected).
Figure 3-3 System Power Settings
To Next Page
Loading...
