Cisco AIR-AP1252AG-A-K9 - Checking the Lightweight Access Point LEDs

4-3
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 4 Troubleshooting 1250 Series Lightweight Access Points
Checking the Lightweight Access Point LEDs
Checking the Lightweight Access Point LEDs
If your lightweight access point is not working properly, check the Status, Ethernet, and Radio LEDs on
the 2.4 GHz end of the unit. You can use the LED indications to quickly assess the unit’s status.
Figure 4-1 shows the access point LEDs (for additional information refer to the Event Log using the
access point browser interface).
Figure 4-1 Access Point LEDs
ETHERNET STATUS RADIO
230563
ETHERNET STATUS RADIO