Cisco Aironet 1240AG Series - Mounting below a Suspended Ceiling

Draft 1A - CISCO CONFIDENTIAL
2-8
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-7293-01
Chapter 2 Installing the Access Point
Mounting Below a Suspended Ceiling
Mounting Below a Suspended Ceiling
Note To comply with NEC code, a #10-24 grounding lug is provided on the mounting plate.
You should review Figure 2-4 before beginning the mounting process.
Figure 2-4 T-Rail Mounting Parts ---- TBD -----
Follow these steps to mount your access point on a suspended ceiling:
Step 1 Decide where you want to mount the access point.
Step 2 Attach two T-rail clips to the suspended ceiling T-rail.
Step 3 Use the mounting plate to adjust the distance between the T-rail clips so that they align with the holes in
the mounting plate.
Step 4 Use a standard screwdriver to tighten the T-rail clip studs in place on the suspended ceiling T-rail. Do
not overtighten.
Step 5 Install a plastic spacer on each T-rail clip stud. The spacer’s legs should contact the suspended ceiling
T-rail.
Step 6 Attach the mounting plate to the T-rail clip studs and start a Keps nut on each stud.
1 Suspended ceiling T-rail 4 mounting plate
2 T-rail clips 5 Keps nut (contains an attached lock washer)
3 Plastic spacer
1
2
2
3
5
3
4
5
74121