Cisco ASA 5540 - Page 1566

67-102
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 67 Clientless SSL VPN
Configuring Bookmarks
Using Variables 7 - 10
Each time the adaptive security appliance recognizes one of these four strings in an end-user request (a
bookmark or a post form), it replaces it with the user-specific value before passing the request to a
remote server.
Example 1: Setting a Homepage
The following example sets a URL for the homepage:
• WebVPN-Macro-Value1 (ID=223), type string, is returned as wwwin-portal.example.com
• WebVPN-Macro-Value2 (ID=224), type string, is returned as 401k.com
To set a home page value, you would configure the variable substitution as
https://CSCO_WEBVPN_MACRO1, which would translate to https://wwwin-portal.example.com.
The best way to do this is to configure the Homepage URL parameter in ASDM.
Go to the Add/Edit Group Policy pane, from either the Network Client SSL VPN or Clientless SSL VPN
Access section of ASDM, as in Figure 67-9Using ASDM to Configure a Macro that Sets a Homepage.
The paths are as follows:
• Configuration > Remote Access VPN > Network (Client) Access > Group Policies > Add/Edit
Group Policy > Advanced > SSL VPN Client > Customization > Homepage URL attribute.
• Configuration > Remote Access VPN > Clientless SSL VPN Access > Group Policies > Add/Edit
Group Policy > More Options > Customization > Homepage URL attribute.
Figure 67-9 Using ASDM to Configure a Macro that Sets a Homepage
Example 2: Setting a Bookmark or URL Entry
You can use an HTTP Post to log in to an OWA resource using an RSA one-time password (OTP) for
SSL VPN authentication, and then the static, internal password for OWA e-mail access. The best way to
do this is to add or edit a bookmark entry in ASDM (Figure 67-10).
There are several paths to the Add Bookmark Entry pane, including the following:
• Configuration > Remote Access VPN > Clientless SSL VPN Access > Portal > Bookmarks >
Add/Edit Bookmark Lists > Add/Edit Bookmark Entry > Advanced Options area > Add/Edit Post
Parameters (available after you click Post in the URL Method attribute).
or
(Available after you click Post in the URL Method attribute):