Cisco ASR 1000 Series - Page 296

10-6
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 10 Cisco ASR 1002-X Router Overview and Installation
Cisco ASR 1002-X Router Description
Figure 10-4 shows the Cisco ASR 1002-X Router slot numbering.
Figure 10-4 Cisco ASR 1002-X Router Slot Numbering
The Cisco ASR 1002-X Router has an integrated ESP which is not field upgradeable. Depending on the
Cisco optional software license that is installed, the ESP forwarding bandwidth can be software field
upgraded from the default bandwidth of 5 Gbps to 10 Gbps, 20 Gbps, or 36 Gbps. For more information
about the software license, see the Cisco ASR 1000 Series Aggregation Services Routers Release Notes
at: http://www.cisco.com/en/US/docs/routers/asr1000/release/notes/asr1k_rn_rel_notes.html
Table 10-1 describes the LEDs on the integrated ESP.
Table 10-1 Integrated ESP LEDs
Power Supplies in the Cisco ASR 1002-X Router
The Cisco ASR 1002-X Router power supply module supports the following Cisco power supplies:
• AC power supply operates between 85 V ac to 264 V ac
• –48 V DC power supply operates between –40.5 V dc and –72 V dc
1 Built-in 6x1GE SPA in slot 0 4 SPA slot 2
2 SPA slot 1 5 ESP LEDs
3 SPA slot 3
1
45 3
2
360935
No. LED Label LED Color Behavior in the Power-Up State
1 PWR Power Solid green All the power supplies are within operational limits.
Off Off. The router is in standby mode.
2 ACTV Active Green The ESP is green when active.
3 STAT STATUS Green Code has successfully downloaded, and is
operational.
Yellow Boot ROM has successfully loaded.
Red Not booted.
4 STBY Standby None Will always be off.