Cisco ASR 1000 Series - Page 307

10-17
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 10 Cisco ASR 1002-X Router Overview and Installation
Rack-Mounting the Cisco ASR 1002-X Router
Note Ensure that the cable management U feature device has the open end pointing upwards when you
attach it to the chassis
Figure 10-9 Attaching the Cable Management Brackets to the Cisco ASR 1002-X Router
Step 6 Screw the cable management bracket to each side of the rack mount brackets already attached to the
chassis. Use two screws for each cable management bracket. Use the packet of four screws.
Step 7 Verify if all the screws are securely tightened.
Step 8 Go to the “Attaching a Chassis Ground Connection” section on page 10-26 to continue the installation.
Rack-Mounting the Cisco ASR 1002-X Router
The Cisco ASR 1002-X Router can be installed in an existing rack with equipment or in an empty rack
with no equipment. The chassis can be mounted on either of these rack types:
• Two-post rack, either 19-inch or 23-inch equipment rack. Inner clearance (the width between the
inner sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis
is 3.47 inches (8.8 cm). Air flow through the chassis is from front to back.
• Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8
cm). Air flow through the chassis is from front to back.
Note When handling the chassis, always follow proper lifting practices. See the “Chassis-Lifting Guidelines”
section on page 5-23.
1 Cable management bracket top and bottom
screw
3 Chassis front rack mount bracket
2 Cable management bracket — —
333423
1
3
2
1