Figure 16: Attach Cable Guides
Step 2 Secure the cable guides with the two M6x12mm screws supplied with the cable kit. The recommended
maximum torque is 26 inch-pounds (3 newton meters).
Wall Mount
Install the wall mounting brackets and cable guides on to the chassis before you mount the chassis on the wall.
Install Wall Brackets
The device is shipped with wall mounting brackets that are to be secured on the sides of the device.
Procedure
Step 1 Remove the wall mounting brackets from the accessory kit and position them beside the device.
You can install the brackets as shown in the figure.
Note
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
34
Install the Router
Wall Mount
To Next Page
Loading...
