Install Wall Brackets 34
Wall Mount the Device 35
Ground the Device 36
Connect Power Cables 37
Activate an AC Power Supply 38
Attach Cables to the DC Power Supply 40
Power On the DC Power Supply 41
Connect Gigabit Ethernet Ports 41
Connect SFP Modules 42
Install SFP Modules 42
Remove SFP Modules 43
Connect Fiber Optic SFP Modules 43
Connect RJ-45 Connector 44
Connect Chassis to Network 44
Connecting Console Cables 44
Connecting to the USB Serial Port Using Microsoft Windows 45
Connecting to the Console Port Using Mac OS X 46
Connecting to the Console Port Using Linux 46
Installing the Cisco USB Device Driver 47
Uninstalling the Cisco USB Device Driver 47
Connecting a USB Flash Device 48
Removing a USB Flash Device 48
Connecting Timing Cables 49
Connecting a Cable to the BITS Interface 49
Connecting Cables to the GPS Interface 49
Connect to EIA Console Port 50
Connect a Management Ethernet Cable 51
Configure the Device 53
CHAPTER 5
Power up the Device 53
Verify the Front Panel LEDs 53
Verify the Hardware Configuration 54
Check Hardware and Software Compatibility 54
Configure Device at Startup 54
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
v
Contents
To Next Page
Loading...
