• 9600 baud
• 8 data bits
• No parity
• 1 stop-bit
• No flow control
Connect a Management Ethernet Cable
When using the Ethernet Management port in the default mode (speed-auto and duplex-auto), the port operates
in the auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity through the
Auto-MDI/MDI-X feature, and senses a crossover or straight-through cable and adapts to it.
However, the Ethernet Management port may be configured to a fixed speed (10, 100, or 1000 Mbps) through
command-line interface (CLI) commands. In such a case, the port is forced to operate in the MDI mode.
When in a fixed-speed configuration and MDI mode, use:
• a crossover cable to connect to an MDI port
• a straight-through cable to connect to an MDI-X port
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
51
Install the Router
Connect a Management Ethernet Cable
To Next Page
Loading...
