Cisco ASR1004 - ASR 1004 Modular Expansion Base - Chapter 4 Preparing to Install a SIP or a SPA; Required Tools and Equipment; Safety Guidelines; Safety Warnings

CHAPTER
4-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
4
Preparing to Install a SIP or a SPA
This chapter describes the general equipment, safety, and site preparation requirements for installing
SIPs and SPAs. This chapter contains the following sections:
• Required Tools and Equipment, page 4-1
• Safety Guidelines, page 4-1
• Laser/LED Safety, page 4-9
Required Tools and Equipment
You need the following tools and parts to install SIPs and SPAs. If you need additional equipment,
contact a service representative for ordering information.
• Shared port adapter interface processor (SIP)
• Shared port adapter (SPA)
• Number 1 Phillips screwdriver
• Number 2 Phillips screwdriver
• 3/16-inch flat-blade screwdriver
• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap supplied with the SIP or SPA
• Antistatic mat
• Antistatic container
Safety Guidelines
This section provides safety guidelines that you should follow when working with any equipment that
connects to electrical power or telephone wiring.
Safety Warnings
Safety warnings appear throughout this publication in procedures that, if performed incorrectly, might
harm you. A warning symbol precedes each warning statement.