5-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 5 Installing and Removing a SIP
Online Insertion and Removal
--------- ------------------- --------------------- -----------------
0 ASR1000-SIP10 ok 1w0d
1 ASR1000-SIP40 ok 1w0d
1/1 SPA-5X1GE-V2 ok 1w0d
2 ASR1000-SIP40 ok 1w0d
2/1 SPA-1X10GE-L-V2 ok 1w0d
2/3 SPA-1X10GE-L-V2 ok 1w0d
3 ASR1000-SIP40 ok 1w0d
3/3 SPA-4XT3/E3 ok 1w0d
4 ASR1000-SIP40 ok 1w0d
4/2 SPA-5X1GE-V2 ok 1w0d
4/3 SPA-4XCT3/DS0 ok 1w0d
5 ASR1000-SIP40 ok 1w0d
R0 ASR1000-RP2 ok, active 1w0d
R1 ASR1000-RP2 ok, standby 1w0d
F0 ASR1000-ESP40 ok, active 1w0d
P0 ASR1013-PWR-AC ok 1w0d
P1 ASR1013-PWR-AC ps, fail 1w0d
P2 ASR1013-PWR-AC ok 1w0d
P3 ASR1013-PWR-AC ps, fail 1w0d
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 00200800 15.0(1r)S
1 00200800 15.0(1r)S
2 00200800 15.0(1r)S
3 00200800 15.0(1r)S
4 00200800 15.0(1r)S
5 00200800 15.0(1r)S
R0 10021901 15.0(1r)S
R1 10021901 15.0(1r)S
F0 1001270D 15.0(1r)S
Preparing for Online Removal of a SPA
The Cisco ASR 1000 Series Routers support the OIR of a SPA independent of removing the SIP. This
means that a SIP can remain installed in the Cisco ASR 1000 Series Router with one SPA remaining
active, while you remove another SPA from one of the SIP subslots. If you are not planning to
immediately replace a SPA into the SIP, ensure that you install a blank filler plate in the subslot. The
SIP should always be fully installed with either functional SPAs or blank filler plates.
If you are planning to remove a SIP along with its SPAs, you do not have to follow the instructions
provided in this section. To remove a SIP, see the “Preparing for Online Removal of a SIP” section on
page 5-2.
Deactivating a SPA
Although graceful deactivation of a SPA is recommended using the hw-module subslot stop command
in EXEC mode, the Cisco ASR 1000 Series Routers support the removal of the SPA without deactivating
it first. Before deactivating a SPA, ensure that the SIP is seated securely in the slot before you pull out
the SPA.
To Next Page
Loading...
