5-10
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 5 Installing and Removing a SIP
SIP Installation and Removal
Step 4 Tighten the locking thumbscrews on both sides of the SIP.
Step 5 Connect all cables to each SPA.
To remove a SIP, refer to Figure 5-2 and do the following:
Step 1 To remove the SIP, first disconnect all cables from each SPA.
Step 2 Loosen the locking thumbscrews on both sides of the SIP.
Step 3 Slide the SIP out of the router slot. If you are removing a blank filler plate, pull the blank filler plate
completely out of the router slot.
To Next Page
Loading...
