6-3
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 6 Installing and Removing a SPA
Removing a SPA from a SIP
Follow the procedure to install one set of the shipped cable clips to the already installed plastic pull tab
on the SPA. Figure 6-2 shows the SPA with the plastic pull tab installed.
Figure 6-2 Installed Cisco ASR 1000 Series SPA Plastic Pull Tab
To install a cable clip to each side of the SPA, follow these steps:
Step 1 Select one set of cable clips from the SPA accessory kit. Figure 6-3 shows the cable clip options.
275930
2
1
1 SPA 2 Plastic pull tab (shipped with the SPA)
To Next Page
Loading...
