6-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 6 Installing and Removing a SPA
Removing a SPA from a SIP
Note The cable clip is designed to easily snap into position.
Step 3 Install another cable clip to the other side of the SPA. Figure 6-5 shows the cable clip fully inserted into
the plastic pull tab on a SPA.
Figure 6-5 Cisco ASR 1000 Series SPA with a Cable Clip Installed
Step 4
You have installed the cable clip to the SPA. Go to the next step to remove the SPA.
Step 5 If attached, remove any cables from the SPA.
Step 6 To remove the SPA from the SIP, unfasten the captive installation screws on either side of the SPA.
Figure 6-6 illustrates how to remove a SPA in a SIP.
1 Cable clip 2 SPA plastic pull tab
275932
1
2
To Next Page
Loading...
