Cisco ASR1004 - ASR 1004 Modular Expansion Base - SPA Cable Management Brackets

6-10
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 6 Installing and Removing a SPA
SPA Cable Management Brackets
SPA Cable Management Brackets
SPAs are shipped with an accessory kit that includes cable management brackets. Figure 6-7 shows
cable management brackets installed in a SPA, as well as cable routing.
Figure 6-7 SPA Cable Management Brackets
To install cable management brackets on a SPA, perform the following steps:
Step 1 Screw the two pull assemblies into both sides of the SPA.
Step 2 Insert the cable management bracket into the slot.
Step 3 To remove the cable management bracket, depress the button on the bracket and pull it out.
Note Blank filler plugs are provided if no cable management brackets are installed.
3
ST
A
T
U
S
2
0
3
1
M
O
D
U
L
A
R
S
E
R
V
IC
E
S
C
A
R
D
231509
S
PA
-4XO
C
3-A
TM
STA
TU
S
0
C
/A
A
/L
0
C
/A
A
/L
0
C
/A
A
/L
0
C
/A
A
/L
STATU
S