7-20
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 7 Troubleshooting the Installation
Packing a SIP for Shipment
Packing a SIP for Shipment
This section provides step-by-step instructions for packing a SIP for shipment. Before beginning this
procedure, you should have the following original Cisco packaging materials:
• Static shielding bag
• Corrugated spacer
• Bottom support
• Smaller inner carton
• Two foam packing cushions
• Larger exterior carton
Note For information on removing a SIP, see the “SIP Installation and Removal” section on page 5-9.
Caution The Cisco original packaging is to be used for the shipment of all SIPs. Failure to properly use Cisco
packaging can result in damage or loss of a product.
Caution During this procedure, wear grounding wrist straps to avoid ESD damage to the card.
See Preventing Electrostatic Discharge Damage, page 4-8 for information about preventing ESD.
Note These instructions assume that the SIP has been removed from the router according to the recommended
procedures specified in this guide.
To pack a SIP for shipment, see Figure 7-2, and perform the following steps:
Step 1 Insert the SIP into the static shielding bag. (Not shown in diagram.)
Step 2 Place the bottom support into the smaller inner carton.
Step 3 Place the bagged SIP onto the bottom support.
Step 4 Place the corrugated spacer on top of the bagged SIP.
Step 5 Close the smaller inner carton and tape the sides closed.
Step 6 Place the sealed smaller inner carton containing the SIP into the two foam packing cushions (the carton
only fits one way).
Step 7 Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
larger exterior carton with tape for shipment.
To Next Page
Loading...
