Cisco ASR1004 - ASR 1004 Modular Expansion Base - Modular Optics Compatibility

1-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 1 SIP and SPA Product Overview
Modular Optics Compatibility
Modular Optics Compatibility
Some SPAs implement small form-factor pluggable (SFP) optical transceivers to provide network
connectivity. An SFP module is a transceiver device that mounts into the front panel to provide network
connectivity.
Cisco qualifies the SFP modules that can be used with SPAs.
Table 1-5 SIP and SPA Compatibility for Service SPAs
SPA Product ID
SIP Supported:
Cisco ASR1000-SIP10
SIP Supported:
Cisco ASR1000-SIP40
Cisco WebEx Node for ASR 1000
Series
SPA-WMA-K9 Yes Yes
Cisco DSP SPA for ASR 1000
Series
SPA-DSP Yes Yes
Table 1-6 SIP and SPA Compatibility for CEoP SPA
SPA Product ID
SIP Supported:
Cisco ASR1000-SIP10
SIP Supported:
Cisco ASR1000-SIP40
1-Port Channelized OC3/STM-1
ATM and Circuit Emulation SPA
1
1. Restriction: The SPA-1CHOC3-CE-ATM is not supported on the Cisco ASR 1001 Router (1 RU chassis), but supported
on all other ASR 1000 chassis. All the other ASR 1000 Routers support the SPA-1CHOC3-CE-ATM for Circuit Emulation
application; but not ATM applications. Effective from Cisco IOS XE Release 3.3.0S, the SPA-1CHOC3-CE-ATM is
supported only with these software images: ADVANCED ENTERPRISE SERVICES, ADVANCED ENTERPRISE W/O
CRYPTO, ADVANCED IP SERVICES, or ADVANCED IP SERVICES W/O CRYPTO. The SPA-1CHOC3-CE-ATM is
not supported with these software images: IP BASE and IP BASE W/O CRYPTO.
SPA-1CHOC3-
CE-ATM
Yes Yes
2-Port Channelized T3/E3 ATM
CEoP SPA
2
2. Restriction: Effective from Cisco IOS XE Release 3.4.0S, the SPA-2CHT3-CE-ATM is supported on Cisco ASR 1000
Series Router. The SPA-2CHT3-CE-ATM is not supported on the Cisco ASR 1001 Router (1 RU chassis), but supported
on all other ASR 1000 chassis. However, the SPA-2CHT3-CE-ATM supports only the T3 ATM mode in Cisco IOS XE
Release 3.4.0S and not the Circuit Emulation (CEM) mode. Maximum Virtual Circuits supported are 1024. Interim Local
Management Interface (ILMI) 1.0 is not supported. IETF RFC 2364 and 2516 for Point-to-Point Protocol (PPP) over ATM
is not supported. IETF RFC 1577 support for classical IP and Address Resolution Protocol (ARP) over ATM is not
supported. ATM Forum UNI 3.0, 3.1, and 4.0 is not supported. Effective from Cisco IOS XE Release 3.5.0S, the
SPA-2CHT3-CE-ATM supports ATM on clear-channel E3 SPA. All the existing ATM features are supported in the E3
mode.
SPA-2CHT3-C
E-ATM
24-Port Channelized T1/E1 ATM
CEoP SPA
3
3. Restriction: The SPA-24CHT1-CE-ATM is not supported on the Cisco ASR 1001 Router (1 RU chassis), but supported
on all other ASR 1000 chassis. Effective from Cisco IOS XE Release 3.4.0S, the SPA-24CHT1-CE-ATM supports only
the CEM mode. Effective from Cisco IOS XE Release 3.4.0S, the SPA-24CHT1-CE-ATM is supported only with these
software images: ADVANCED ENTERPRISE SERVICES, ADVANCED ENTERPRISE W/O CRYPTO, ADVANCED
IP SERVICES, or ADVANCED IP SERVICES W/O CRYPTO. The SPA-24CHT1-CE-ATM is not supported with these
software images: IP BASE and IP BASE W/O CRYPTO.
SPA-24CHT1-
CE-ATM
Yes Yes