3-24
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
10-Port Gigabit Ethernet SPA Overview
See the “SFP Module and Cabling Specifications for Gigabit Ethernet SPAs” section on page 3-25 for
SFP module options, module specifications, and cabling specifications.
For CWDM and DWDM SFP module specifications, see the “CWDM and DWDM SFP Modules for
Gigabit Ethernet SPAs” section on page 3-29.
10-Port Gigabit Ethernet SPA Overview
The following sections describe the 10-Port Gigabit Ethernet SPA:
• 10-Port Gigabit Ethernet SPA LEDs, page 3-24
• 10-Port Gigabit Ethernet SPA Connectors, page 3-25
• SFP Module and Cabling Specifications for Gigabit Ethernet SPAs, page 3-25
• CWDM and DWDM SFP Modules for Gigabit Ethernet SPAs, page 3-29
10-Port Gigabit Ethernet SPA LEDs
The 10-Port Gigabit Ethernet SPA has two types of LEDs: an A/L LED for each port on the SPA, and
one STATUS LED, as shown in Figure 3-19.
Figure 3-19 10-Port Gigabit Ethernet SPA Faceplate
Table 3-14 describes the 10-Port Gigabit Ethernet SPA LEDs.
1 A/L (Active/Link) LED 2 STATUS LED
Table 3-14 10-Port Gigabit Ethernet SPA LEDs
LED Label Color State Meaning
A/L Off Off Port is not enabled.
Green On Port is enabled and the link is up.
Amber On Port is enabled and the link is down.
STATUS Off Off SPA power is off.
To Next Page
Loading...
