Contents
viii
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Verifying the Deactivation and Activation of a SPA 5-8
Deactivation and Activation Configuration Examples 5-8
Deactivation of a SIP Configuration Example 5-8
Activation of a SIP Configuration Example 5-9
Deactivation of a SPA Configuration Example 5-9
Activation of a SPA Configuration Example 5-9
SIP Installation and Removal 5-9
CHAPTER
6 Installing and Removing a SPA 6-1
Handling SPAs 6-1
SPA Installation and Removal 6-2
Installing a SPA in a SIP 6-2
Removing a SPA from a SIP 6-2
Online Insertion and Removal 6-6
Optical Device Maintenance 6-6
Cleaning Optical Devices 6-7
Checking the Installation 6-7
Verifying the Installation 6-7
Using show Commands to Verify the SIP and SPA Status 6-8
Using show Commands to Display SPA Information 6-9
SPA Blank Filler Plates 6-9
SPA Cable Management Brackets 6-10
CHAPTER
7 Troubleshooting the Installation 7-1
Troubleshooting the Hardware 7-1
SIP is Deactivated 7-2
SIP Transitions Repeatedly from On to Off 7-3
Troubleshooting the Cisco WebEx Node and SPA-DSP for ASR 1000 Series Hardware 7-3
Cisco WebEx Node SPA and SPA-DSP is in Out-of-Service State 7-3
Cisco WebEx Node SPA Has Issued Hardware Error Messages 7-7
Hard Disk Drive Errors on the Cisco WebEx Node SPA 7-8
Collecting the show tech-support Output from the Cisco WebEx Node SPA Console 7-10
Reformatting the Hard Disk Drive on the Cisco WebEx Node SPA 7-11
Prerequisites 7-11
Troubleshooting the 1-Port 10-Gigabit Ethernet LAN/WAN-PHY SPA for ASR 1000 Series
Hardware
7-14
Feature Change to CPU-Usage show Command 7-15
Using debug Commands 7-17
To Next Page
Loading...
