Cisco ASR1004 - ASR 1004 Modular Expansion Base - 1-Port OC-48 C;Stm-16 POS SPA Leds

3-39
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
1-Port OC-48c/STM-16 POS SPA Overview
• 1-Port OC-48c/STM-16 POS SPA LEDs, page 3-39
• 1-Port OC-48c/STM-16 POS SPA Interface Specifications, page 3-40
• 1-Port OC-48c/STM-16 POS SPA Optical Transceiver Modules, Connectors, and Cables, page 3-41
1-Port OC-48c/STM-16 POS SPA LEDs
The 1-Port OC-48c/STM-16 POS SPA has eight LEDs, as shown in Figure 3-25.
Figure 3-25 1-Port OC-48c/STM-16 POS SPA Faceplate
Note The WRAP, PASSTHRU, and MATESYNC LEDs apply to the SPA in RPR/SRP mode only.
Table 3-24 describes the 1-Port OC-48c/STM-16 POS SPA LEDs.
1 WRAP LED 5 CARRIER LED
2 PASSTHRU LED 6 ACTIVE LED
3 MATESYNC LED 7 A/L (Active/Loopback) LED
4 C/A (Carrier/Alarm) LED 8 STATUS LED
SPA-1XOC48PO
S/RPR
MATESYNC
PA SSTHRU
WRAP
ACTIVE
CARRIER
SPA-1XOC12-PO
S
STATU
S
0
A/L
C/A
4
1
2
5
6
3
7
8
149965
Table 3-24 1-Port OC-48c/STM-16 POS SPA LEDs
LED Label Color State Meaning
WRAP Off Off Port is not in wrap mode.
Green On Port is in wrap mode somewhere on the ring.
Amber On Port is in wrap mode locally.
PASSTHRU Off Off Port is not in pass-through mode.
Amber On Port is in pass-through mode.
MATESYNC Off Off Mate port is not synchronized.
Green On Mate port is synchronized.
C/A Off Off Port is not enabled by software.
Green On Port is enabled by software.
Amber On Port is enabled by software, and there is at least one alarm.
A/L Off Off Port is not enabled by software.