EasyManua.ls Logo

Cisco ASR1004 - ASR 1004 Modular Expansion Base - Connectors, and Cables

Cisco ASR1004 - ASR 1004 Modular Expansion Base
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-50
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-12
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs
2-Port, 4-Port, and 8-Port OC-12c/STM-4 POS SPA Overview
2-Port, 4-Port, and 8-Port OC-12c/STM-4 Multirate POS SPA Optical Transceiver
Modules, Connectors, and Cables
The 2-Port, 4-Port, and 8-Port OC-12c/STM-4 Multirate POS SPA uses a small form-factor pluggable
(SFP) optical transceiver module installed in each port for SONET multimode optical fiber connection
(see Figure 3-33).
The 2-Port, 4-Port, and 8-Port OC-12c/STM-4 Multirate POS SPA supports the following types of
optical transceiver modules:
Multimode (MM) SFP module—SFP-OC12-MM
Short-reach (SR) SFP module—SFP-OC12-SR
Intermediate-reach (IR) SFP module (15 km)—SFP-OC12-IR1
Long-reach (LR) SFP module (40 km)—SFP-OC12-LR1
Long-reach (LR) SFP module (80 km)—SFP-OC12-LR2
Figure 3-33 SFP Optics Module
The SFP optical transceiver modules used with the 2-Port, 4-Port, and 8-Port OC-12c/STM-4 Multirate
POS SPA provide the following optical fiber options:
Multimode—622.08-Mbps, OC-12c/STM-4 optical fiber (SONET STS-12c or SDH STM-4)
Use a multimode optical fiber that has a core/cladding diameter of 62.5/125 microns.
Single-mode—622.08-Mbps, OC-12c/STM-4 optical fiber (SONET STS-12c or SDH STM-4)
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ± 0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
For single-mode and multimode optical fiber connections, you can use either a duplex LC-type cable (see
Figure 3-34) or two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Use single-mode (for short-, intermediate- or long-reach configurations) or multimode optical fiber
cable to connect your router to a network or to connect two OC-3-equipped or OC-12-equipped routers
back-to-back.
Long-range SFP optical transceiver modules (for long-reach configurations) cannot be connected
back-to-back without using an attenuator between the two of them.
127158

Table of Contents

Related product manuals