DescriptionField
Enable or disable IP dialing. If IP dialing is enabled, you can dial
[userid@] a.b.c.d[:port], where ‘@’, ‘.’, and ‘:’ are dialed by entering *,
user-id must be numeric and a, b, c, d must be between 0 and 255; the
port must be larger than 255. If port is not given, 5060 is used. Port and
User-Id are optional. If the user-id portion matches a pattern in the dial
plan, then it is interpreted as a regular phone number according to the
dial plan. The INVITE message, however, is still sent to the outbound
proxy if it is enabled.
Default setting: no
Enable IP Dialing.
Comma separated list of emergency number patterns. If outbound call
matches one of the patterns, the ATA disables hook flash event handling.
The condition is restored to normal after the call ends. Blank signifies
that there is no emergency number. Maximum number length is 63
characters.
Default setting: blank
Emergency Number
Enter the ID number of the mailbox for this line.
Default setting: blank
Mailbox ID
Allows the phone to synchronize with the call server. If Do Not Disturb
or Call Forwarding settings are changed on the phone, the changes are
also made on the server. If changes are made on the server, they are
propagated to the phone.
Default setting: no
Feature Key Sync
Proxy and Registration
Table 53: Proxy and Registration Parameters
DescriptionField
SIP proxy server for all outbound requests.
Default setting: blank
Proxy
SIP Outbound Proxy Server where all outbound requests are sent as the
first hop.
Default setting: blank
Outbound Proxy
Enables the use of an Outbound Proxy. If set to no, the Outbound Proxy
and Use OB Proxy in Dialog parameters are ignored.
Default setting: no
Use Outbound Proxy
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
78
Voice Settings Configuration
Proxy and Registration
To Next Page
Loading...
Need help?
General
